Liquid mixer RND
- Product Introduction
- Installation Form
Installing from top: The agitator rod should be stuck into the tank for liquid mixing from the right above the tank center or deviate the tank center, creating the up and down convection and mixing between the liquid and agitator blades. You should consider the phenomenon generated by the liquid and blades while mixing if the rod，is installed from the center above the tank, forcing the liquid and blades are relatively stable. Especially, the faster the agitator is mixing, the easier the situation will be present. You should equip with blocking board from the inside of the tank to reduce the revolving phenomenon for such situation. The size of the blocking board is determined by the density or viscosity of the liquid and mixer speed. After adding the blocking board, the resistance of the liquid mixing will be increased so the motor power should be enlarged. The mixing efficiency is the lowest for this installation method. The mixing effect will be better if you stick the rod deviate the tank center from above. No resolving phenomenon. In addition, you don’t need to equip with blocking board to prevent the resolving problem. We suggest to place bearing to fix the rod if its length is over 2 meters, extending the lifespan of the agitator.
Need service or support? Welcome to enable the online message function, we will give you timely feedback and provide you with suitable solutions.
Exist for electromechanical technology and develop for intelligent transmission!